Pipe Wrap_Pipe_Sock.JPG

Pipe Sock™

  • Description
  • Technical Specs
  • Installation
  • Downloads

The Pipe Sock™ system is a fiber-reinforced polymer designed to eliminate crevice corrosion problems caused by direct metal-to-metal contact. It consists of a pre-formed, size specific fiberglass wear pad and a specially formulated adhesive system that combines to form a resilient crevice corrosion solution. Additionally, it can withstand temperatures up to 250° F and provide complete fit-up integrity with the pipe, eliminating moisture penetration and condensation cavities.

Mechanical Properties
Attribute Tensile Strength 
Method ASTM D 3039
Value 54,000 psi

Attribute Compression Strength
Method ASTM D 695 
Value 
28,500 psi

Attribute Barcol Hardness
Method ASTM D 2583
Value 
53

Thermal Properties

Attribute Max Operating Temperature 
Value 250° F (121 °C)

Attribute Application Temperature
Value 41 °F to 95° F (5 °C to 35 °C)

System Properties

Attribute Wear Pad Thickness
Value 0.25 inches (6.35 mm)

Attribue Shelf Life – Black Magic ™
Value 18 months

01.png1. Remove Pipe from Support 
Lift the corroded pipe off support or stanchion.

 

 

 

02.png2. Surface Inspection and Preparation 
Brush contact surface with a wire brush and lightly abrade with sandpaper to remove loose dirt and scale. Inspect the area and repair any anomalies, as required.

 

 

03.png3. Apply Black Magic 
Remove release liner from the PipeSock™ and apply Black Magic™adhesive to the inside of the PipeSock™.

 

 

 

04.png4. Install PipeSock and Reposition Pipe 
Carefully position the PipeSock™ on the pipe. Then, lower the pipe on to the support. Taper any excess material with a putty knife.    

Click here to read the techincal data sheet. 

Request more information about this product.

Contact Us